285/35R22 vs 285/40R22
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Not recommended — Exceeds the 3% diameter limit — speedometer error and ABS/TPMS issues likely.
To scale
285/35R22
- Section width
- 285 mm
- Aspect ratio
- 35%
- Rim diameter
- 22"
- Sidewall
- 99.8 mm
- Overall diameter
- 758.3 mm
- Circumference
- 2382 mm
- Revs / mile
- 676
- Revs / km
- 420
285/40R22
- Section width
- 285 mm
- Aspect ratio
- 40%
- Rim diameter
- 22"
- Sidewall
- 114.0 mm
- Overall diameter
- 786.8 mm
- Circumference
- 2472 mm
- Revs / mile
- 651
- Revs / km
- 405
Difference
- Overall diameter
- +28.5 mm (+3.76%)
- Sidewall height
- +14.3 mm
- Tread width
- +0 mm
- Ride height (axle)
- +14.3 mm
- Speedometer error
- +3.76%
- At indicated 60 mph
- actual 62.3 mph
- At indicated 100 km/h
- actual 103.8 km/h
Will 285/40R22 fit instead of 285/35R22?
The overall diameter changes by 3.76%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).