285/25R22 vs 285/30R22
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Not recommended — Exceeds the 3% diameter limit — speedometer error and ABS/TPMS issues likely.
To scale
285/25R22
- Section width
- 285 mm
- Aspect ratio
- 25%
- Rim diameter
- 22"
- Sidewall
- 71.3 mm
- Overall diameter
- 701.3 mm
- Circumference
- 2203 mm
- Revs / mile
- 730
- Revs / km
- 454
285/30R22
- Section width
- 285 mm
- Aspect ratio
- 30%
- Rim diameter
- 22"
- Sidewall
- 85.5 mm
- Overall diameter
- 729.8 mm
- Circumference
- 2293 mm
- Revs / mile
- 702
- Revs / km
- 436
Difference
- Overall diameter
- +28.5 mm (+4.06%)
- Sidewall height
- +14.3 mm
- Tread width
- +0 mm
- Ride height (axle)
- +14.3 mm
- Speedometer error
- +4.06%
- At indicated 60 mph
- actual 62.4 mph
- At indicated 100 km/h
- actual 104.1 km/h
Will 285/30R22 fit instead of 285/25R22?
The overall diameter changes by 4.06%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).