255/30R19 vs 255/35R19
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Not recommended — Exceeds the 3% diameter limit — speedometer error and ABS/TPMS issues likely.
To scale
255/30R19
- Section width
- 255 mm
- Aspect ratio
- 30%
- Rim diameter
- 19"
- Sidewall
- 76.5 mm
- Overall diameter
- 635.6 mm
- Circumference
- 1997 mm
- Revs / mile
- 806
- Revs / km
- 501
255/35R19
- Section width
- 255 mm
- Aspect ratio
- 35%
- Rim diameter
- 19"
- Sidewall
- 89.3 mm
- Overall diameter
- 661.1 mm
- Circumference
- 2077 mm
- Revs / mile
- 775
- Revs / km
- 481
Difference
- Overall diameter
- +25.5 mm (+4.01%)
- Sidewall height
- +12.8 mm
- Tread width
- +0 mm
- Ride height (axle)
- +12.8 mm
- Speedometer error
- +4.01%
- At indicated 60 mph
- actual 62.4 mph
- At indicated 100 km/h
- actual 104.0 km/h
Will 255/35R19 fit instead of 255/30R19?
The overall diameter changes by 4.01%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).