235/30R20 vs 245/30R20
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Safe to swap — Diameter difference is under 1.5% — within normal tolerance.
To scale
235/30R20
- Section width
- 235 mm
- Aspect ratio
- 30%
- Rim diameter
- 20"
- Sidewall
- 70.5 mm
- Overall diameter
- 649.0 mm
- Circumference
- 2039 mm
- Revs / mile
- 789
- Revs / km
- 490
245/30R20
- Section width
- 245 mm
- Aspect ratio
- 30%
- Rim diameter
- 20"
- Sidewall
- 73.5 mm
- Overall diameter
- 655.0 mm
- Circumference
- 2058 mm
- Revs / mile
- 782
- Revs / km
- 486
Difference
- Overall diameter
- +6.0 mm (+0.92%)
- Sidewall height
- +3.0 mm
- Tread width
- +10 mm
- Ride height (axle)
- +3.0 mm
- Speedometer error
- +0.92%
- At indicated 60 mph
- actual 60.6 mph
- At indicated 100 km/h
- actual 100.9 km/h
Will 245/30R20 fit instead of 235/30R20?
The overall diameter changes by 0.92%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).