225/70R15 vs 235/70R15
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Borderline — Check wheel-arch clearance and reset TPMS before fitting.
To scale
225/70R15
- Section width
- 225 mm
- Aspect ratio
- 70%
- Rim diameter
- 15"
- Sidewall
- 157.5 mm
- Overall diameter
- 696.0 mm
- Circumference
- 2187 mm
- Revs / mile
- 736
- Revs / km
- 457
235/70R15
- Section width
- 235 mm
- Aspect ratio
- 70%
- Rim diameter
- 15"
- Sidewall
- 164.5 mm
- Overall diameter
- 710.0 mm
- Circumference
- 2231 mm
- Revs / mile
- 722
- Revs / km
- 448
Difference
- Overall diameter
- +14.0 mm (+2.01%)
- Sidewall height
- +7.0 mm
- Tread width
- +10 mm
- Ride height (axle)
- +7.0 mm
- Speedometer error
- +2.01%
- At indicated 60 mph
- actual 61.2 mph
- At indicated 100 km/h
- actual 102.0 km/h
Will 235/70R15 fit instead of 225/70R15?
The overall diameter changes by 2.01%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).