225/50R18 vs 235/50R18
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Safe to swap — Diameter difference is under 1.5% — within normal tolerance.
To scale
225/50R18
- Section width
- 225 mm
- Aspect ratio
- 50%
- Rim diameter
- 18"
- Sidewall
- 112.5 mm
- Overall diameter
- 682.2 mm
- Circumference
- 2143 mm
- Revs / mile
- 751
- Revs / km
- 467
235/50R18
- Section width
- 235 mm
- Aspect ratio
- 50%
- Rim diameter
- 18"
- Sidewall
- 117.5 mm
- Overall diameter
- 692.2 mm
- Circumference
- 2175 mm
- Revs / mile
- 740
- Revs / km
- 460
Difference
- Overall diameter
- +10.0 mm (+1.47%)
- Sidewall height
- +5.0 mm
- Tread width
- +10 mm
- Ride height (axle)
- +5.0 mm
- Speedometer error
- +1.47%
- At indicated 60 mph
- actual 60.9 mph
- At indicated 100 km/h
- actual 101.5 km/h
Will 235/50R18 fit instead of 225/50R18?
The overall diameter changes by 1.47%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).