215/50R17 vs 225/50R17
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Borderline — Check wheel-arch clearance and reset TPMS before fitting.
To scale
215/50R17
- Section width
- 215 mm
- Aspect ratio
- 50%
- Rim diameter
- 17"
- Sidewall
- 107.5 mm
- Overall diameter
- 646.8 mm
- Circumference
- 2032 mm
- Revs / mile
- 792
- Revs / km
- 492
225/50R17
- Section width
- 225 mm
- Aspect ratio
- 50%
- Rim diameter
- 17"
- Sidewall
- 112.5 mm
- Overall diameter
- 656.8 mm
- Circumference
- 2063 mm
- Revs / mile
- 780
- Revs / km
- 485
Difference
- Overall diameter
- +10.0 mm (+1.55%)
- Sidewall height
- +5.0 mm
- Tread width
- +10 mm
- Ride height (axle)
- +5.0 mm
- Speedometer error
- +1.55%
- At indicated 60 mph
- actual 60.9 mph
- At indicated 100 km/h
- actual 101.5 km/h
Will 225/50R17 fit instead of 215/50R17?
The overall diameter changes by 1.55%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).