205/70R14 vs 215/70R14
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Borderline — Check wheel-arch clearance and reset TPMS before fitting.
To scale
205/70R14
- Section width
- 205 mm
- Aspect ratio
- 70%
- Rim diameter
- 14"
- Sidewall
- 143.5 mm
- Overall diameter
- 642.6 mm
- Circumference
- 2019 mm
- Revs / mile
- 797
- Revs / km
- 495
215/70R14
- Section width
- 215 mm
- Aspect ratio
- 70%
- Rim diameter
- 14"
- Sidewall
- 150.5 mm
- Overall diameter
- 656.6 mm
- Circumference
- 2063 mm
- Revs / mile
- 780
- Revs / km
- 485
Difference
- Overall diameter
- +14.0 mm (+2.18%)
- Sidewall height
- +7.0 mm
- Tread width
- +10 mm
- Ride height (axle)
- +7.0 mm
- Speedometer error
- +2.18%
- At indicated 60 mph
- actual 61.3 mph
- At indicated 100 km/h
- actual 102.2 km/h
Will 215/70R14 fit instead of 205/70R14?
The overall diameter changes by 2.18%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).