205/55R15 vs 205/60R15
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Not recommended — Exceeds the 3% diameter limit — speedometer error and ABS/TPMS issues likely.
To scale
205/55R15
- Section width
- 205 mm
- Aspect ratio
- 55%
- Rim diameter
- 15"
- Sidewall
- 112.8 mm
- Overall diameter
- 606.5 mm
- Circumference
- 1905 mm
- Revs / mile
- 845
- Revs / km
- 525
205/60R15
- Section width
- 205 mm
- Aspect ratio
- 60%
- Rim diameter
- 15"
- Sidewall
- 123.0 mm
- Overall diameter
- 627.0 mm
- Circumference
- 1970 mm
- Revs / mile
- 817
- Revs / km
- 508
Difference
- Overall diameter
- +20.5 mm (+3.38%)
- Sidewall height
- +10.3 mm
- Tread width
- +0 mm
- Ride height (axle)
- +10.3 mm
- Speedometer error
- +3.38%
- At indicated 60 mph
- actual 62.0 mph
- At indicated 100 km/h
- actual 103.4 km/h
Will 205/60R15 fit instead of 205/55R15?
The overall diameter changes by 3.38%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).