175/65R14 vs 175/70R14
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Not recommended — Exceeds the 3% diameter limit — speedometer error and ABS/TPMS issues likely.
To scale
175/65R14
- Section width
- 175 mm
- Aspect ratio
- 65%
- Rim diameter
- 14"
- Sidewall
- 113.8 mm
- Overall diameter
- 583.1 mm
- Circumference
- 1832 mm
- Revs / mile
- 879
- Revs / km
- 546
175/70R14
- Section width
- 175 mm
- Aspect ratio
- 70%
- Rim diameter
- 14"
- Sidewall
- 122.5 mm
- Overall diameter
- 600.6 mm
- Circumference
- 1887 mm
- Revs / mile
- 853
- Revs / km
- 530
Difference
- Overall diameter
- +17.5 mm (+3.00%)
- Sidewall height
- +8.8 mm
- Tread width
- +0 mm
- Ride height (axle)
- +8.8 mm
- Speedometer error
- +3.00%
- At indicated 60 mph
- actual 61.8 mph
- At indicated 100 km/h
- actual 103.0 km/h
Will 175/70R14 fit instead of 175/65R14?
The overall diameter changes by 3.00%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).