175/60R15 vs 175/65R15
Side-by-side comparison of overall diameter, sidewall height, speedometer error, and ride-height change.
Borderline — Check wheel-arch clearance and reset TPMS before fitting.
To scale
175/60R15
- Section width
- 175 mm
- Aspect ratio
- 60%
- Rim diameter
- 15"
- Sidewall
- 105.0 mm
- Overall diameter
- 591.0 mm
- Circumference
- 1857 mm
- Revs / mile
- 867
- Revs / km
- 539
175/65R15
- Section width
- 175 mm
- Aspect ratio
- 65%
- Rim diameter
- 15"
- Sidewall
- 113.8 mm
- Overall diameter
- 608.5 mm
- Circumference
- 1912 mm
- Revs / mile
- 842
- Revs / km
- 523
Difference
- Overall diameter
- +17.5 mm (+2.96%)
- Sidewall height
- +8.8 mm
- Tread width
- +0 mm
- Ride height (axle)
- +8.8 mm
- Speedometer error
- +2.96%
- At indicated 60 mph
- actual 61.8 mph
- At indicated 100 km/h
- actual 103.0 km/h
Will 175/65R15 fit instead of 175/60R15?
The overall diameter changes by 2.96%. Most manufacturers consider a swap acceptable when the difference stays under 3% — beyond that, you may see speedometer error, ABS/TPMS warnings, or wheel-well clearance problems. This page only covers the math; your vehicle's wheel arches, suspension geometry, and load rating still matter.
What the numbers mean
- Overall diameter — outside-to-outside height of the tire. Affects ride height, gearing, and speedometer calibration.
- Sidewall height — rubber from rim edge to tread. Lower sidewall gives sharper steering response but a harsher ride.
- Speedometer error — how far off your indicated speed will be after the swap. Positive means the speedo under-reads (actual speed is higher than shown).